Bunnings Warehouse catalogue - 1 Jan - 31 Jan 2022 - NO LONGER VALID - page 73 *

thumbnail - Bunnings Warehouse mailer - 01.01.2022 - 31.01.2022 - Sales products - daybed, mattress, cushion, roller, drill, circular saw, saw, handsaw, jig. Page 73.
73 / 85

* Valid at all Bunnings Warehouse stores

Show more

Products in this catalogue

 
lounging spot wath 3 Position the back frame against the wall, pre-drill with a 5mm bit and secure into studs with 100mm batten screws and a hex bit. Position the supports flat between the back and front frames, along the floor and flush with the top rail, centring them to match the noggins. Add a noggin between the supports at either end. Secure all joints using a pocket hole jig with Custom-built drawers keep exercise kit tidied away when not in use 32mm screws. The finished 2490mm X 970mm x 425mm daybed spans the width of the space 6 To make the drawers, 7 To clad the front, 8 To make the top, from 9 Smooth all over with use a pocket hole jig 19mm plywood, cut 120-grit abrasive paper working widthways on a sheet of 9mm plywood, and 32mm screws to 1075mm x 1833mm and to remove any breakout, secure the back against use a circular saw with 1075mm x 653mm panels. then finish with 180-grit, the base, attach the Position over the frame, straightedge to cut a 35mm x 1180mm panel rounding over the edges and corners slightly. sides, then secure the with the join along a to position under the drawers. Cut a 342mm support, to mark notches for the wall studs, cutting Wipe away dust with a damp cloth and tape front with 13.5mm overhang either side. To install the drawer slides, strip to make two 587mm drawer faces, then cut them with a handsaw. around the walls and use a level to mark the Reposition panels, countersinking into the inside the drawers. Use dividers 140mm up from 379mm strips to make a mini microfibre roller the floor for runners, and two 653mm panels and frame and securing with 50mm screws. Tip: Adjust the depth of your top to fit if it doesn't require to apply two coats of water-based enamel, leaving to dry after 100mm up from the base position either side of of the drawers for the the drawers. Countersink guides, securing with into the frame and each. Fit the drawer 15mm countersunk drawers to secure with notching around handles and add a timber screws. 50mm screws. exposed studs. mattress with cushions. bunnings.com.au |O bunnings | bunnings 73

Other Bunnings Warehouse catalogues

Latest catalogues